Safety Mats
Safety Contact Mats are used for safeguarding areas of danger on machines and plants with the aim of preventing unchecked access. The switching mat can be individually adapted to the area which has to be secured. With the help of the closed-circuit-principle a constant monitoring of the safety contact edge is insured.
Contact mats are used on…
machines, plants and robotic systems where the areas of danger are unchecked accessed plants where the presence of a person at a certain position is necessary elevators, in order to prevent the unallowed entering of the elevator roof building entrances
Functional Description
- The STM safety contact-making mat is fitted with two two-core connecting cables and offers the possibility of connecting several mats in series up to a maximum total area of 10 m2. One end of the cable is connected to the evaluation electronics and the terminal resistance is connected to the other end (prepared accordingly at the factory). The electronics now monitor the entire conductor route, including the mats, through to the terminal resistance.
- The contact-making surfaces make contact in the event of external forces acting on the mat and the resistance is bridged. This immediately causes a signal within the electronics that is then given as a potential-free output for contact-making by the relay. The entire switching arrangement is monitored at the same time for cable rupture or manipulation.
Safety Switchgear SK 41-322 RLU
The single-channel SK 41-322 RLU switchgear finds application in the evaluation of safety contact mats as well as in providing security of pinch and shear points caused by safety contact edges and safety bumpers. The switchgear is designed in accordance with EN 954-1 for Category 3. In order to meet Category 3 requirements, the switchgear has been designed to be redundant, diversified, and equipped with two safety relays which query each other and are force guided. In order to permit the quiescent current of the circuit element to be monitored, a terminal resistor has been integrated in the signal transmitter. When the desired quiescent current is flowing, the output relay is activated and the switching contact is closed. If the signal transmitter is activated or the safety circuit is interrupted, the relay switching contact opens. The switch states of the relays and the applied circuit voltage are indicated by LEDs.
